Publicité
Les langues disponibles
Les langues disponibles
PROBLEM
No fuel.
Engine will
not start (see
Low oil
Engine Manual
Pressure builds up after two pulls
for further
on the recoil starter or after initial
engine
use.
troubleshooting)
Choke lever in the "No Choke"
position.
Spark plug wire not attached.
Engine ON/OFF switch in OFF
position.
Choke lever in the "Choke"
position on a "hot" engine or an
engine that has been exposed to
thermal heat for a long period of
time.
Fuel valve closed
No or low
Spray wand not in high pressure.
pressure
(initial use)
Low water supply.
Leak at high pressure hose fitting.
Nozzle obstructed.
Water filter screen clogged.
Air in hose.
Choke lever in the "Choke" position. Move choke to the "No Choke"
High pressure hose is too long.
TROUBLE SHOOTING GUIDE
CAUSE
Add Fuel.
Add required amount of oil.
Squeeze gun trigger to relieve
pressure.
Move choke to the "Choke"
position.
Attach spark plug wire.
Place engine ON/OFF switch in
ON position.
Move choke to the "No Choke"
position.
Move the fuel valve lever to the
"Open" position.
See How to Use Spray Wand
instructions in the Operation
Section.
Water supply must be at least 5
GPM @ 20 PSI.
Repair leak. Apply sealant tape
if necessary.
See Nozzle Cleaning instructions
in the Maintenance section.
Remove and clean filter.
Turn off the engine, then the
water source. Disconnect the
water source from the pump inlet
and turn the water source on
to remove all air from the hose.
When there is a steady stream
of water present, turn water
source off. Re-connect water
source to pump inlet and turn on
water source. Squeeze trigger to
remove remaining air
position.
Use high pressure hose under
100 feet.
15- ENG
CORRECTION
A13548
Publicité
