Rolsen RL-32X11 Manuel Du Propriétaire page 8

- You can connect additional equipment, such as VCRs, camcorders etc. to your set. However please check with your
manufacturers instruction books for specific information. Make sure all connections are made with both your set and
additional appliance unplugged from the mains to avoid damaging your equipment. Here shown may be somewhat dif-
ferent from your set.
1 1
Connect to Aerial socket
Connect the RF out socket of the VCR to the aerial
socket on the back of the set.
Connect the aerial cable to the RF aerial in socket
of the VCR.
Store the VCR channel on a desired programme
number using the 'Manual programme tuning' sec-
tion.
Select the programme number where the VCR
channel is stored.
Press the PLAY button on the VCR.
8
2
Watching VCR
< Back panel of the set >
VCR
- If you connect an S-VIDEO VCR to the S-VIDEO input, the pic-
ture quality is improved; compared to connecting a regular VCR
to the Video input.
- To avoid picture noise (interference), leave an adequate dis-
tance between the VCR and set.
Use the INPUT SELECT button on the remote control to select
AV1
(If connected to S-VIDEO, select the
source.)
Insert a video tape into the VCR and press the PLAY button on the
VCR. (See VCR owner's manual)
2
Y P b P r
COMPONENT INPUT COMPONENT INPUT
AV1 V1 AV2 V2
(480i/480p/720p/1080i) (480i/480p/720p/1080i)
S-VIDEO
OUT
(R) AUDIO (L)
IN
< Back panel of VCR >
or AV2 .
< Back panel of the set >
OPTICAL OPTICAL S-VIDEO S-VIDEO
ANT. IN ANT . IN
VIDEO
S-Video external input