Rolsen RL-32X11 Manuel Du Propriétaire page 34

RGB Mode / DVI Mode
MODE
DOS
VGA
SVGA
XGA
SXGA
WXGA
UXGA
MAC
(Synchronization input form : separate)
34
Horizontal Vertical
Resolution
Frequency (Hz)
Frequency (KHz)
640X350 70.0
61.5
70.0
31.5
720X400
85.0
37.9
60.0
31.5
72.0
37.8
640X480
75.0
37.5
85.0
43.2
56.0
35.1
60.0
37.9
800X600
72.0
48.0
75.0
46.9
85.0
53.7
60.0
48.4
70.0
56.4
1024X768
75.0
60.0
85.0
60.0
60.0
63.9
70.0
75.0
1280X1024
75.0
79.9
85.0
91.1
60.0
47.7
75.0
1280X768
60.1
85.0
68.5
60.0
1360X768
49.0
60.0
1366X768 49.0
60.0
1600X1200 75.0
75.0
832X624 49.7
Note:
a. If the set is cold, there may be a small "flicker" when the set
is switched on. This is normal, there is nothing wrong with
the set.
b. If possible, use the VESA 1,024x768@60Hz video
mode to obtain the best image quality for your LCD
monitor. If used to PC vertical frequency 85Hz, some
noise can be seen when PIP is on. In this case, set the
PC vertical frequency to 60Hz. The set has been pre-
adjusted to the mode VESA 1,024x768@60Hz.
c. Some dot defects may appear on the screen, like Red,
Green or Blue spots. However, this will have no impact
or effect on the monitor performance.
d. Do not press the LCD screen with your finger for a long
time as this may produce some temporary distortion
effects on the screen.
e. When the PC screen appears on the set, a message may
appear on the screen, and the message will differ accord-
ing to the Window system version (Win98, 2000). If a
message appears click "Next" until the message finishes.
f. If the message " Out Of Range " appears on the screen,
adjust the PC as in the 'Displayable Monitor Specification'
section.