Set The Video Format According To System, Ex-Sdi Or Hd-Sdi; Osd Menu Startup - Eneo HDD-2080Z03IR D Guide D'installation Rapide

Set the video format according to system, EX-SDI or HD-SDI

To select the camera's output video format (EX-SDI or HD-SDI), use the Video format
Switch on the side of the camera (see also "Using OSD controller" for location of the
switch). Only one format can be used at a time. The Video sub-out Connector signal is not
affected by the switch setting.
Camera (HD-SDI)
1M~120M via
RG59u or 5C2V
cable
Camera (HD-SDI)
1M~120M via
RG59u or 5C2V
cable
Camera (HD-SDI)
Camera (EX-SDI)
Camera (EX-SDI)

OSD menu startup

Press '●' (OSD menu Joy stick key) down for about 2 seconds to access the setup menu
mode.
Lens Initializing is strongly recommended at the first stage of setup menu control. ZOOM/
FOCUS > LENS INIT > Press the joystick '☟' straight down for about 2 seconds.
1M~120M via RG59u or 5C2V cable
1M~120M via RG59u or
5C2V cable
HDA-3000E
(EX-SDI)
350M+ via RG59u or
5C2V cable
HDA-3000E
(EX-SDI)
350M+ via RG59u or 5C2V cable
350M+ via RG59u or 5C2V cable
1M~120M via
RG59u or 5C2V
cable
HDA-3000E
(EX-SDI)
1M~120M via
RG59u or 5C2V
cable
HDA-3000E
(EX-SDI)
1M~120M via
RG59u or 5C2V
cable
HDA-3000E
(EX-SDI)
EN
DVR (HD-SDI)
DVR (HD-SDI)
DVR (HD-SDI)
DVR (HD-SDI)
DVR (EX-SDI)
19