Resetting To The Factory Default Settings - Eneo ISM-53M2812W0A Guide D'installation Rapide

Notice: If the password is lost, the network camera must be reset to the factory
i
default settings. Please see "Resetting to the Factory Default Setting".

Resetting to the factory default settings

To reset the network camera to the original factory settings, go to the Setup > System >
Maintenance web page (described in "System > Maintenance" of Users Manual) or use the
Reset button on the network camera, as described below.
Using the Reset button:
Follow the instructions below to reset the network camera to the factory default settings
using the Reset button.
1. Switch off the network camera by disconnecting the power adapter.
2. Press and hold the Reset button while reconnecting the power.
3. Keep the Reset button pressed until the Status indicator blink.
4. Release the Reset button.
5. When the Power Indicator changes to Green (may take up to 40 seconds), the
process is complete and the network video camera has been reset.
6. The network camera resets to factory defaults and restarts after completing the
factory reset.
7. Close the bottom cap tightly to ensure waterproof.
CAUTION: When performing a Factory Reset, you will lose any settings that have
been saved. (Default IP 192.168.1.10)
EN
17