Resetting To The Factory Default Settings - Eneo IPP-72A0030M0A Guide D'installation Rapide

i Notice: If the password is lost, the network camera must be reset to the factory
default settings. Please see "Resetting to the Factory Default Setting".

Resetting to the factory default settings

To reset the network camera to the original factory settings, go to the Setup > System >
Maintenance web page (described in "System > Maintenance" of Users Manual) or use the
Reset button on the network camera, as described below:
Using the Reset button:
Follow the instructions below to reset the network camera to the factory default settings
using the Reset button.
1. Switch off the network camera by disconnecting the power adapter.
2. Open the Micro-SD card cover.
3. Press and hold the Reset button (SW1) on the board with your finger while recon-
necting the power.
4. Keep the Reset button (SW1) pressed for about 2 seconds.
5. Release the Reset button (SW1).
6. The network camera resets to factory defaults and restarts after completing the
factory reset.
CAUTION: When performing a Factory Reset, you will lose any settings that have been
saved. (Default IP 192.168.1.10)
22
Micro-SD Card Slot Reset button
RS485 termination
switch