Publicité
Les langues disponibles
Les langues disponibles
Programming the "Chrono" mode
a) Setting the current day of the week and time
• Enter into "Stand-by" mode and press the [-] button at
least 3 seconds.
• On the upper part of the display the message "Set" will be
displayed
• To set the day and time press the [+] button until the bot-
tom part of the display the message "TED" is displayed (see
picture on the right).
• Press the [Prog] button to enter the editing mode
• The blinking arrow indicates the currently selected day:
Pressing the [+] / [-] buttons the desired day can then be
set.Press again the [Prog] button to confirm the selected day. After that, the procedure for
entering the time starts and the display shows the currently selected time.
• "Hours": Use the [+] and [-] buttons to set the correct hour and confirm the selected value
pressing the [Prog] button.
• Minutes: Same procedure as for the hours. Confirm the selected value by pressing the [Prog]
button.
• At the end of the procedure, the thermostat returns into "Stand-by" mode.
b) Setting the program for the "Chrono" mode:
• Enter into "Stand-by" mode and press the [-] button at
least 3 seconds.
• On the upper part of the display the message "Set" will be
displayed
• To set the day and time press the [+] button until the bot-
tom part of the display the message "Prog" is displayed (see
picture on the right).
• Press the [Prog] button to enter the editing mode
• Now a time sequence can be defined for each day of
• the week. The procedure starts with day 1, and the desired
sequence can be configured with the [+] and [-] buttons: For each hour of the day, it is then
possible to assign either the "Comfort" temperature (full bar indication displayed) by pressing
the [+] button or the "Night" temperature (empty bar) by pressing the [-] button (see picture
below). Press [PROG] to confirm the entered configuration for day 1, and repeat the same
procedure for the remaining 6 days of the week.
[ 45 ]
Publicité
