Ramiaudio RP500 Manuel Utilisateur page 31

1 - Main switch.
2 - Power cord to connect mains.
3 - Negative regulated voltage indicator.
4 - Positive regulated voltage indicator.
5 - 9 pins female sub D power output to be connected to the rear sub D 9 on the RP500 rear panel.
Warning !
The RP500 power supply mains connector has three wires (2 poles + earth). Earth should imperatively be connected to
mains earth.
Never use this equipement without proper grounding.
,
Check quality of grounding.
,
Should noise or hum occurs when connected to other equipments, never disconnect grounding, use insulating
,
transformer on mains.
Never open the case without disconnecting mains.
,
Avoid high temperature exposure.
,
Never expose the equipment to rain, snow or moisture.
,
Using RP500 headphone amplifier, listening to high level an result in permanent damage to ears.
,
The power supply and RP500 complie with :
EN60065, EN55013, EN55020, EN60555-2, and EN60555-3, according to 73/23/EEC, 89/336/EEC and 93/68/EEC.
RAmi
POWER SUPPLY
IMPORTANT
7
RP500