Freezer Shelf; Caring For Your Refrigerator; Cleaning Your Refrigerator - Whirlpool ET18NKXFN03 Guide D'utilisation Et D'entretien

Freezer Shelf

(on some models)
To remove the shelf:
1. Lift entire shelf slightly.
2. Move shelf all the way to one side.
3. Tilt other side up and out of shelf supports.
4. Pull shelf up and out.
To replace the shelf:
1. Tilt the shelf and insert into freezer compartment.
2. Insert one end of the shelf all the way into the center of
the shelf supports.
3. Lower other end of shelf and insert into the shelf
supports.
4. Lower shelf into place.
NOTE: The shelf should lower slightly and lock into
place. If the shelf does not appear stable, make sure
both ends of the shelf are inserted into the shelf
supports.
CARING FOR YOUR
REFRIGERATOR

Cleaning Your Refrigerator

WARNING
Explosion Hazard
Use nonflammable cleaner.
Failure to do so can result in death, explosion,
or fire.
Both the refrigerator and freezer sections defrost
automatically. However, clean both sections about once a
month to prevent odors from building up. Wipe up spills
immediately.
Energy Saving Tip:
Clean the condenser coils regularly, as described in the
cleaning chart in this section. A coil cleaning brush is
available for purchase (Part Number 4210463).
To clean your refrigerator:
Unplug refrigerator or disconnect power.
Remove all removable parts from inside, such as
shelves, crispers, etc.
Use a clean sponge or soft cloth and a mild detergent in
warm water. Do not use abrasive or harsh cleaners.
Hand wash, rinse, and dry all surfaces thoroughly.
Plug in refrigerator or reconnect power.
17