Publicité
Technical specifications
Pick-up element
Pixel elements 5
Resolution
Gain control
Lens
Iris
Light sensitivity
Scene illumination
Signal to noise ratio
White balance TTL
System connector (output)
Microphone
• Frequency range
Synchronisation
Power supply
Power consumption
System-cable length
Dimensions
Weight
Connectors
• System cable
• External power
Auto-iris control
Mounting
Ambient temperature
• Operating
• Storage
Ambient humidity
• Operating
• Storage
The pin connections of the auto-iris connector are:
pin 1 = control coil -
pin 2 = control coil +
pin 3 = drive coil -
pin 4 = drive coil +
88
1/3" solid state CCD
12 (H) x 582 (V), PAL interlaced, or 512(H) x 492 (V), NTSC
interlaced
330 TVL
automatic
See: Using a different lens
Electronic iris
When connected, an auto-iris lens overrides the electronic iris.
• 0.3 lux minimally acceptable picture with standard lens (F1.2)
at 3200K, transmission 86%, scene reflection 100%
• 0.5 lux, 50ire (-6dB) with standard lens (F1.2) at 3200K,
transmission 86%, scene reflection 100%
Not for continuous use above 2k lux with standard lens (F1.2)
For outdoor use an auto-iris lens is recommended.
48dB at 200-25000 lux, 25°C
range 2500-6500K
RJIIE plug
Built-in, can be switched off at the camera.
300-3000Hz
The camera automatically synchronises to the system monitor.
24VDC, when the system-cable length exceeds 200m/600ft a power-
adapter (24VDC, current limit 500mA) is required (available as
accessory)
≤3W
max. 300m/900ft (when a mains power adaptor is used)
72,5 (H) x 70 (W) x 60 (D) mm (excl. lens)
190g
RJ11E modular ("telephone" plug)
Power jack
4-pole socket, passive Auto-iris, direct drive
1/4" 20 UNC
-10 to +50°C
-25 to +70°C
20 to 90% RH
up to 99% RH
4 2
3 1
CL 66610005_309.AI
Publicité
