Odys SLIM DV SDV i5 Mode D'emploi page 22

When using the camcorder:
Problem
Cannot use the flash strobe.
The camcorder does not
respond to any action during
operation.
The recorded pictures appear
too blurred.
The recorded pictures or
video clips appear too dark.
Noises occur when viewing
images on the LCD screen or
on the computer.
I want to restart the serial
number of the file name
(PICTxxxx).
I convert a media file and
name it as PICTxxxx.* (xxxx
indicates number). Then I
copy the file to the camcorder
but cannot find it on the
camcorder.
10
Appendix: A
Cause
If the battery icon indicates
low battery, the flash strobe
may be disabled due to
insufficient voltage.
The camcorder encounters
software failure.
The focus is not correctly set.
The environment of shooting
or recording does not have
adequate light.
The flicker setting does not
match the standard of the
area you are staying.
The counting of the serial
number is handled by the
camcorder firmware.
There is another file with
duplicate serial number
(e.g. PICT0001.ASF and
PICT0001.JPG), or the file
type is not supported.
Solution
Replace the battery.
Remove the battery pack
and replace it into the
compartment. Then power on
the camcorder.
Adjust the focus to an
appropriate position.
Use flash strobe when taking
pictures. Add extra light
sources or enable video light
when recording video clips.
Adjust the flicker setting. For
more information, please
refer to the "Flicker Settings"
table.
Use the camcorder "Format"
function to format the card.
Give the file a distinctive
serial number and make sure
the file type is supported by
the camcorder.