Fastbind ELITE Mode D'emploi page 21

CARE AND MAINTENANCE
Section 9
CARE AND MAINTENANCE
Cleaning
Adding glue
Lubrication
Changing drop tray
170 ºC
Service and Spare Parts
www.maping.com
Switch off the unit and pull out the mains plug prior to all cleaning and
maintenance work.
Elite is easy to take care of and serves you well if cleaned periodically. Use a
damp soft cloth with alcohol based solvent or mild detergent solution for this
purpose. Do not use solution containing ammonia or abrasive. Let glue drops
cool down before removal.
Check the glue level now and then. Add only clean and dry hot melt glue to
applicator reservoir. Let the machine warm up properly before using it again.
If glue is added to empty tank (glue on minimum level), it may take longer
than 20 min to re-heat the applicator. Do not re-use glue drops from the drop
collector tray. These contain impurities that can block the applicator.
When necessary, use a soft cloth with a few drops of machine oil on the adhesive
applicator's guide rail. Apply slighly oil or silicon on clamp guide rods now
and then. This is the easiest way to protect rods from glue drops - and makes
them easily removable. When machine is cold, check and remove old glue drops
regularly from drop collector plate under the adhesive applicator.
Change drop tray or remove excessive glue under adhesive applicator from time
to time. This is the easiest way to prevent melted glue to cause problems with
chain driving glue roller.
!
For service and component replacements, contact your dealer or Fastbind
authorized service outlet. Use only accessories and spare parts approved
by the manufacturer.
N O N O
glue
recycling
MELTED GLUE
1 - 20
MAX. LEVEL
DO NOT
OVERFILL!
MIN. LEVEL
MIN. LEVEL
IS HOT !
REV. d5 Elite Multilang
© 2004.12 Maping Co