Binding A Scratch Pad - Fastbind ELITE Mode D'emploi

BINDING A SCRATCH PAD (BOOK WITHOUT COVER)
Section 8
BINDING A SCRATCH PAD (BOOK WITHOUT COVER)
Check List & Preparations
Binding Procedure
8.1. LOADING PAPERS
8.1.1
a)
8.1.2
a)
www.maping.com
Before you begin, ensure that
• Τhere is glue in the applicator reservoir (Fastbind Hot-Melt )
•
Machine has warmed up at least
•
Softcover nipping plate is attached (marked with "S")
• Τhe turntable is in normal position
• Τhe paper guide is in place (S or H-model)
PREPARATIONS:
Fold A4 or letter size silicon release paper sharply along the long
a.
side so that the folding line divides the paper in approximately
ratio 30 : 70%. The width of the silicon paper should be larger than
binding width. If spine pressing is preferred, the paper should be
so long that it comes on the top of the nipping tool.
Open the clamp and place the folded silicon paper on
positioning deck. It slides in easily when inserted from
below
a)
Place the papers that make the book between the turntable
and clamp.
a, b) Adjust papers from side and top carefully to ensure
Push the clamp forward and lock it by lifting the clamp
handle up. To keep the turntable still during this action, put
your left hand on clamp's left knob when lifting the handle.
b) Turn the table over (UP) by pushing the operating handle up.
Fold the
for adhesive application.
1 - 18
20 min.
Note the length of the silicon paper. It extends on the
top of the nipping tool. This prevents silicon paper
being crumpled when nipping tool moves.
that it aligns correctly with the cover.
silicon release paper
back and the block is ready
REV. d5 Elite Multilang
© 2004.12 Maping Co