Fein ABLK18-1.3TE Mode D'emploi page 15

Working instructions.
Before mounting or replacing application tools or accessories, remove the bat-
WARNING
tery. This preventive safety measure rules out the danger of injuries through
accidental starting of the power tool.
Do not use accessories not specifically intended and recommended for this power tool by FEIN.
The use of non-original FEIN accessories can lead to overheating of the power tool and destroy
it.
For each job, use only the FEIN application tool released and intended for the
CAUTION
respective application.
Switching on and off.
Always hold the power tool
CAUTION
firmly. Otherwise, you could
lose control over the power tool.
Guide the power tool toward the work
piece only when switched on.
While cutting, hold the power tool as upright
as possible to the work-piece surface.
Guide the power tool uniformly and with
light feed in the cutting direction. Excessive
feed considerably reduces the tool life of the
application tools.
Do not cut steel sheets where welded. Do
not cut layered sheets exceeding the max.
work-piece thickness.
Switching on and off (figure 5).
Switching on:
Push the switch toward the front (I).
Switching off:
Push the switch toward the rear ().
To increase the tool life of punch and die, it is
recommended to apply a lubricating agent
alongside the intended cutting line:
– For cuts in steel sheet: Use cutting paste or
cutting oil.
– For cuts in aluminum: Use petroleum.
For inside cuts, a pilot hole is required; see
Technical data for diameters.
Do not switch the power tool off until after
having removed it from the cutting path.
The symptom for worn punches and dies are
a clearly increased feed force at lower work-
ing progress.
Punch and die cannot be reground.
Fig. 5
en
On/Off switch
15