DOMUS LINE LEDYE collection Manuel D'installation page 8

INSTALLATION MANUAL
CONNECTING THE DEVICE TO THE POWER SUPPLY _ static
light configuration
- Connect the device power cable to an appropriate (check
plate data printed on the product label) safe power supply
with stabilised voltage (not included) with power 10% higher
than the total load.
- If more than one device must be connected to the power
supply ensure that the total sum of the power absorbed by
the devices (check the plate data shown on the product
label) does not exceed the maximum power permitted by
the Converter.
- DOMUS Line guarantees the product only if powered with a
Converter supplied by us.
CONNECTING THE DEVICE TO THE POWER SUPPLY _ Tunable
White dynamic light configuration
- Connect the LEDYE TW power supply cable to one of the light
colour dynamic adjustment systems (for example MAGIC TUNE,
TOUCH TW, etc., sold separately) and with power at least 10%
greater than the total load. For the total load calculation check
plate data printed on the product label.
- For installation and operation of the light colour dynamic
adjustment system see the specific item's manual.
- Then connect the light colour dynamic adjustment system to a
safe power supply with 24Vdc stabilised voltage (sold separately)
and with power at least 10% higher than the total load. For the
total load calculation check plate data printed on the product
label.
EN
- If more than one device must be connected to the power supply
unit ensure that the total sum of the power absorbed by the
devices (check the plate data shown on the product label) does
not exceed the maximum power permitted both by the dynamic
adjustment system and by the Converter.
- DOMUS Line guarantees the product only if powered with
Converters and dynamic light adjustment systems supplied by us.
HOW DOES THE LEDYE HE TD (TOUCH-DIMMER)
WORK?
– The LEDYE TD includes an electronic dimmer switch that
can be switched on and off and that can adjust light
intensity
– The device is simply switched on and off by quickly
touching its screen, under wich the switch (D) is placed,
which is always located at the end of the profile (figure 5).
– A prolonged touch can increase or decrease the device's
brightness and a short flash of the device indicates that its
maximum brightness has been obtained.
– The brightness level obtained will be recalled until the next
adjustment.
– The LEDYE TD device has a safety program that switches
itself off after 18 hours of continuous operation.
WARNING:
This device must be connected directly to the electricity
power supply and must never be connected downstream of
other electronic switches, or near to electromagnetic sources.