empasa Optical Pro Mode D'emploi page 53

Disposal
Please help protect the environment. A public return system exists for disposing of packaging materials and old products.
Information on collection points and current regulations are obtainable from your city or local administration.
Troubleshooting
Problems
Ignition flame doesn't ignite
Ignition flame stops burning
Burner doesn't ignite
Possible causes
Gas valve might be shut
Fuel gas tank empty
Opening blocked
Air in supply system
Battery empty
Loose connection
Contaminations around ignition
flame device
Note also point "Activation" on page 53.
Defective thermal element
Gas leak in pipe
Low fuel pressure
Low gas pressure
Opening blocked
Control not on
Ignition flame assembly unit bent
out of shape or not at right location.
53
Solutions
Open gas valve
Fill liquid gas bottle
Clean or replace opening
Rinse air supply pipes
Exchange with battery of same type
Check and tighten all connections
Clean contaminated area
Exchange thermal element
Check connections
Gas bottle almost empty
Gas bottle almost empty
Remove, clean and reinsert
Turn valve to On
Position ignition flame device properly
and try again
V2/2018-EM-Optical