empasa Optical Pro Mode D'emploi page 51

Activation
Note:
Ÿ
When ignition flame doesn't ignite or if it is extinguished, turn control to "OFF". It needs to be in OFF position for 5 minutes
before ignition can be attempted again. Ensure that the control is in OFF position before igniting the gas heater again.
Ÿ If a new gas bottle has been newly connected, let gas pipe air escape through the ignition flame hole for at least one
minute.
Ÿ When igniting the flame, ensure that the variable control is pressed the whole time while ignition button is pressed. The
variable control can be released once the ignition flame is burning.
Ÿ You can observe and control the ignition flame through the little round window with sliding cover (Figs. 1 and 2) situated at
bottom of radiation shade. The ignition flame an also be lit with a match. Slide the sliding cover to the side in order to ignite
the ignition flame through the hole with a match.
Battery
Deactivation
For turning of gas heater, do the following:
 Press and turn the variable control to "OFF" position.
‚ Shut the valve of gas supply bottle completely.
Note:
Ÿ After usage, do not touch or move the gas heater for at least 45
minutes. RISK OF BURNS!
Ÿ Let all burner elements cool prior to touching.
Fig. 1
Battery
51
Fig. 2
V2/2018-EM-Optical