Function - marklin 216 Serie Mode D'emploi

Safety Notes
• This locomotive is to be used only with an operating system
designed for it (Märklin AC, Märklin Delta,
Märklin Digital or Märklin Systems).
• Use only switched mode power supply units and transformers
that are designed for your local power system.
• This locomotive must never be supplied with power from more
than one transformer.
• Pay close attention to the safety notes in the
instructions for your operating system.
• The feeder track must be equipped to prevent interference with
radio and television reception, when the locomotive is to be run
in conventional operation. The 74046 interference suppression
set is to be used for this purpose.
• Do not expose the model to direct sunlight, extreme changes
in temperature, or high humidity.
• WARNING! Sharp edges and points required for operation.
General Notes
• The operating instructions and the packaging are a compo-
nent part of the product and must therefore be kept as well as
transferred along with the product to others.
• Please see your authorized Märklin dealer for repairs or spare
parts.
• http://www.maerklin.com/en/imprint.html
• The warranty card included with this product specifies the
warranty conditions.
4
Functions
• Recognition of the mode of operation: automatic.
• Addresses that can be set:
1-80 (Control Unit 6021/Mobile Station 60651/652)
1-255 (Central Station 60***/Mobile Station 60653)
• Address set at the factory: 72
• Adjustable acceleration/braking delay (simultaneous) (ABV).
Adjustable maximum speed.
• Setting the locomotive parameters (address, acceleration/
braking delay, maximum speed): with the Control Unit, Mobile
Station, Central Station.
• Headlights, changing over with the direction of travel.
• Only the train control functions and headlight changeover
feature are available in analog operation.
IR-Controler:
Position of the switch note
!