V2 ELETTRONICA GOLD230V-D Notice D'installation page 41

Photocell 2 input
This menu allows enabling the input for type 2 photocells, that is to
say, photocells non active during the opening phase (see paragraph
"Installation").
no input disabled (ignored by the control unit).
No jumper with the common is required.
CF.CH input enabled even at standstill gate too: the opening
movement does not start if photocell is interrupted.
CH input enabled for the closing phase only
Warning: if you select this option, you must disable photocell
test.
Photocell Operational Test
In order to achieve a safer operation for the user, the unit performs a
photocell operational test, before a normal working cycle.
If no operational faults are found, the gate starts moving. Otherwise, it
will stand still and the flashing light will stay onfor 5 sec. The whole
test cycle lasts less than one second.
no the test function is not active
Si the test function is active
WARNING: The PHOTOCELL OPERATIONAL TEST should be working
in order to grant more safety during installation and programming.
Safety ribbon 1 input
This menu allows enabling the input for type 1 safety ribbon, that is to
say, fixed ribbons (see paragraph "Installation").
no input disabled (ignored by the control unit).
No jumper with the common is required.
Si input enabled.
Safety ribbon 2 input
This menu allows enabling the input for type 2 safety ribbon, that is to
say mobile ribbons (see paragraph "Installation").
no input disabled (ignored by the control unit).
No jumper with the common is required.
Si input enabled.
End of Stroke Inputs
Pd8 control unit allows connecting four mechanical ends of stroke
(normally closed contacts) which are activated by the door motion and
showing to the control unit that each door reached its position of
complete opening or closing.
no end of stroke inputs are disabled
Si end of stroke inputs are enabled
38