Wolf 30 62 543 Mode D'emploi Et Instructions De Montage page 4

Notes on installation
Installing the backing plate
Electrical connection
Remote control
Backing plate
Addressing of the remote
control
DIP-switches
marked in white
4
Installation/Operation
Analog Remote Control for WRS
- Mount the remote control (RC) on an interior wall at a height of
approx. 1.5 meters above floor level.
- In order for the room-temperature sensor to operate correctly,
the RC must be installed where the temperature is typical.
- Make sure the RC is not concealed behind furniture or drapes.
- Thermostatic valves on radiators in this room must all be fully
open.
- Disengage the backing plate from the RC.
- Secure the backing plate to a dia. 55mm wall box or directly to
the wall.
Only trained, qualified electricians are permitted to connect the
wiring.
Switch off the main switch
-
- Wire the RC with 2-core cable (min. cross-section 0.5mm²) as
illustrated in the sketch below.
Green plug
of controller
Bus
The remote control can be assigned to a heating circuit via four
DIP-switches on its back. By this the adjustments of the remote
control always affect the assigned heating circuit.
The remote control affects the direct heating circuit as well
as any connected heating circuit being controlled by the
programming unit (BM) with the address "0".
(Factory setting)
The remote control affects the mixing valve circuit no. 1
The remote control affects the mixing valve circuit no. 2
The remote control affects the mixing valve circuit no. 3
The remote control affects the mixing valve circuit no. 4
The remote control affects the mixing valve circuit no. 5
The remote control affects the mixing valve circuit no. 6
The remote control affects the mixing valve circuit no. 7
Remote control for series 5W- controls R12, R16, R20,
R33 and TOK (not for WRS control system)
Remote control affects any connected heating circuit
Rem.contact
by others
Terminals,
RC
30 62 425_0309