Nannio Eye Manuel De L'utilisateur page 16

Troubleshooting
You don't getting any signal at all
Ÿ Make sure the camera and the monitor are turned on.
Ÿ Make sure the power plugs are pushed all the way in.
If the signal is poor, or there is interference
Ÿ If there is a microwave oven in use in the path between the camera and
monitor, remove the microwave oven or turn it off.
Ÿ Make sure the camera and the monitor are within range of each other
(range of approximately 500 feet; 150 meters in a clear line of sight).
Ÿ If the power LED is on but only voice signal input is detected, the monitor
can be in voice-activated mode. Press the VOX button to turn on the screen.
Care and Maintenance
Ÿ Keep all parts and accessories out of children's reach.
Fingerprints or dirt on the lens surface can adversely affect camera
Ÿ
performances. Avoid touching the lens surface with your fingers.
Should the lens become dirty, use a blower to blow off dirt and dust, or a
Ÿ
soft, dry cloth to wipe off the lens.
Ÿ Keep the camera dry. Precipitation, humidity, and other liquids contain
minerals will corrode electronic circuits.
Do not use or store in dusty, dirty areas.
Ÿ
Do not store in hot areas. High temperatures can shorten the life of
Ÿ
electronic devices and warp or melt certain plastics.
Do not store in very cold areas. When the system warms up (to its normal
Ÿ
temperature), moisture can form inside the case, which may damage
electronic circuit boards.
Do not attempt to open the case. Non-expert handling of the device may
Ÿ
damage the system.
Avoid dropping or strong shocks.
Ÿ
Operate this product using only with the power supply included or provided
Ÿ
as an accessory.
Do not overload electrical outlets or extension cords this can result in fire
Ÿ
or electric shocks.
6