Care And Cleaning; Troubleshooting; Maintenance - HAMPTON BAY NTSW30030LBL-MS Guide D'utilisation Et D'entretien

Care and Cleaning

To clean the fixture, use a dry or slightly dampened cloth to wipe the glass and surface of the fixture. Do not use any
cleaners with chemicals, solvents, or harsh abrasives. If necessary, use a mild soap to clean off any dirt or stains.

Troubleshooting

Problem
The light will not come on.
The fuse blows or a circuit
breaker trips when the light is
turned on.

Maintenance

REPLACING THE LED DRIVER
□ Turn off main power at fuse or circuit breaker box.
□ Remove the fixture from the wall.
□ Disconnect the fixture power supply wires from the
branch circuit wires.
□ Remove the two screws holding the driver to the
back plate of the fixture.
□ Cut the cable ties holding the bundled wires
together.
□ Cut each individual colored wire pair immediately
below the crimp/wire connector.
□ Strip each colored wire 3/8 in. from the end of the
wire.
□ Attach the new driver to the back plate with the
previously-removed screws.
□ Connect the driver colored wires to the
corresponding colored fixture wires using wire nuts
or crimp connectors.
□ Reattach the fixture to the wall.
□ Restore power to the fixture.
Possible Cause
The wall switch is turned off.
There is a faulty wire connection.
The circuit breaker is off.
There are crossed wires or the power
wire is not grounded.
8
Solution
Turn on the wall switch.
Access the outlet box, and check and
secure the wire connections.
Ensure the circuit breaker is set in the
On position.
Access the outlet box and fix the wire
connections or consult an electrician