Operation - HAMPTON BAY NTSW30030LBL-MS Guide D'utilisation Et D'entretien

Operation

OPERATION MODES
Set the amount of time you want the lights to stay on after motion is detected: 2 or 6 minutes. After the selected
amount of time, the light will be automatically turned off.
Mode Sensitivity
Switch Position
Stand-by L - Less
Mode
M - Medium
H - High
Auto L - Less
Detection
M - Medium
Mode
H - High
Test Mode L - Less
M - Medium
H - High
Manual L - Less
Override
M - Medium
Mode with
H - High
Auto Reset
Dusk-to- L - Less
Dawn Mode
M - Medium
H - High
Timer Switch
Position
Test, 2, or 6
2 or 6
Test
2 or 6
D to D
Photocell Motion Detector
Lense Indicator Light
Motion Sensor Unit
LED
Test
This is the state when the power is turned on. If you have
turned off the power for a long period of time and upon
restoring power to the fixture, the light will turn on in 2
seconds and remain on for approximately 60 seconds
regardless of motion. Then it enters the Auto Detection Mode
or Test Mode based on the setting of the Timer switch.
This is the normal motion detection mode. The motion
detector turns the light on automatically after sensing
movement in its coverage area at dusk and stays on as long
as motion is detected. When motion stops, the light remains
on for the predetermined time you set (2 or 6 minutes) and
then turns off automatically.
This mode allows you to adjust the sensitivity of the motion
detector to a desired level at dusk or dawn. When motion
stops, the light will turn off in about 5 seconds.
This mode allows you to turn on and off your fixture by
using the existing wall switch, regardless of the presence
of motion. The manual override mode works only when it is
dark (light intensity level is below 30 Lux). The unit resets
itself back to Auto Detection Mode after 8 hours. To activate
the feature, turn the existing wall switch off then back on
within 3 seconds so the light stays on continuously. The unit
will turn off and reset itself to Auto Detection Mode after 8
hours.
In this mode, the light turns on at dusk and off at dawn
automatically, regardless of the presence of motion. The "D to
D" setting ensures lights are non-operational in daylight and
only function at night. To activate, set the Timer switch to the
"D to D" position.
D to D
2" 6"
Time Switch
Mounting Side
7
Please contact 1-877-527-0313 for further assistance.
Explanation
AC Power Supply
L M H
PIR Motion
Sensitivity
Switch
HamptonBay.com