Manufacturer Declaration - Denios DT 1 / 60 Mode D'emploi

7

Manufacturer declaration

For the following specified products:
an ignition hazard assessment in accordance with DIN EN ISO 80079-36; 2016-12 has been carried out.
The assessment was carried out for Equipment group II gases, category 2, explosion group IIB and temperature
class T4.
The above mentioned products have no own potential sources of ignition according to the ignition
hazard assessment when they are used in accordance with the instructions and for expected faults.
The products therefore do not fall under the scope of Directive 2014/34/EU and do not need to be correspondingly
marked.
The equipment operator is obliged in accordance with § 3 (1) of the industrial safety regulations
Notice:
(BetrSichV), to carry out a risk assessment and then, if necessary, to produce an explosion protection
document.
The products are to be included in the equipotential bonding measures in accordance with DIN EN
1755 and TRBS 2153.
The safety instructions in the relevant operating instructions for the above named products must be
observed and complied with.
Bad Oeynhausen, 01.12.2015
Directive 94/9/EC of the European Parliament and Council - Harmonised Standards for Member States for Equipment and Protective Systems for use in Potentially Explosive Atmospheres
DIN EN ISO 80079-36; 2016-12 Non-electrical equipment for use in potentially explosive areas
DIN EN 1755 Safety of industrial trucks - Use in potentially explosive areas - Use in areas with combustible gases, vapours, mists or dusts
TRBS 2153 Technical rules for industrial safety 2153 Avoidance of ignition hazards as a result of electrostatic charge
09-18
Ignition hazard assessment / non-electrical equipment
In accordance with DIN EN ISO 80079-36; 2016-12,
in line with ATEX Directive 2014/34/EU.
Drum dolly FKH
Drum dolly FKR-S2 180 862 and 180 863
Drum dolly FKZ
Carboy cart BK-60 181 315 and 181 316
Drum dolly DT 6
Drum dolly Poly200S
Drum dolly 009_INT
Manufacturer declaration
180 860 and 180 861
181 267 and 181 268
127 147
181 870
..................................
Dipl.-Ing. Joachim Fischer
Innovation Manager
23 / 48