LotusGrill G250 Mode D'emploi page 13

Assembly and Operation Instructions
Assembly
1.
Open the battery case at the bottom of the outer bowl
Close the battery case.
2.
Place the inner bowl
3.
Fill the charcoal container
Put cover on charcoal container
4.
Apply a circular layer of lighter gel on ignition plate
Place ignition plate
5.
Turn the round ventilation control button on outer bowl
Turn it clockwise to maximum position.
IMPORTANT
CAUTION
6.
Light gel until it burns.
7.
Put the cover (2) on the filled charcoal container
plate . Within a short period of time, the charcoal will be glowing.
(4)
CAUTION
8.
Put the grill grid (1)
slots of the inner bowl
the latches.
9.
Hook the latches into the metal loops, and pull down to lock the device. The grill is now a
connected and compact unit.
10.
After approx. 3-4 minutes, LotusGrill is ready for use. Use the On/Off Switch for heat
regulation (8) to regulate heat. The fan stays on during the entire barbecue session.
* Every common type of charcoal can be used. Briquettes do not deliver optimal results.
(5) into the outer bowl
completely with charcoal e. g. LotusGrill* Beech Charcoal*
(3)
(2) .
(4) into inner bowl (5) . We recommend the LotusGrill* Safety Fuel Gel.
In order not to quench the flame, the ventilation needs to be
turned on.
Do not touch the flame!
Place the charcoal container carefully and evenly on the ignition plate!
on top of the inner bowl
(5) . Both metal loops at the side of the grill grid
. Insert four AA batteries
(6)
(6) .
(4) , approx 10 mm (0.4 inches) wide.
(6) on.
(3) and place container on ignition
(5) . Make sure to insert the four metal legs into the
. Mind polarity.
(7)
(1) have to be aligned with
English 13