Safely Disposing Of Packaging Material; Assembling And Installing; Installation; Installation Of Wall-Mounted Illuminator - Videotec GEKO IRH Manuel D'instructions

6.3 Safely disposing of packaging
material
The packaging material can all be recycled. The
installer technician will be responsible for separating
the material for disposal, and in any case for
compliance with the legislation in force where the
device is to be used.
Bear in mind that if the material has to be returned
due to a fault, using the original packaging for its
transport is strongly recommended.
Bear in mind that if the material has to be returned
due to a fault, using the original packaging for its
transport is strongly recommended.

7 Assembling and installing

During normal operation the surface of the
illuminator can reach high temperatures.
Do not, therefore, allow direct contact
and position the appliance where it is
inaccessible to unauthorised persons.
Before touching switch off the illuminator
and allow to cool for a minimum period of
10 minutes.
Do not stare directly into the lamp at a
distance of less than 1.7m.
Only specialised personnel should be
allowed to assemble and install the device.

7.1 Installation

7.1.1 Installation of wall-mounted
illuminator
The illuminator's position can be decided at
the time of installation.
Fig. 2
Fasten the bracket as shown in the figure. Drive the
wall screws in tight.
Fig. 3
Fasten the illuminator, complete with its bracket,
using the screw, the nut and the washer supplied.
Fig. 4
Set the illuminator's vertical and horizontal
inclination by adjusting the two fastening screws.
Fig. 5
Check the resulting illumination range on the
screen.Tighten all the screws.
5