Connecting The Signal Input - Chauvet Professional PVP Serie Manuel De L'utilisateur

Connecting (Cabling) Each PVP™
Connecting the
The VIP™ video wall system uses 2 basic setup configurations to connect the signal to
the video wall:
Signal Input
1. A configuration using 24 or less panels.
2. A configuration using more than 24 panels.
The next section, Connecting Power and Signal Cables, gives information on connecting
power and signal between joined panels and to the rest of the VIP™ system.
The following configuration of 24 panels shows a direct connection from the signal to the
VIP™ Driver into the first panel's Signal Input socket. Refer to the VIP™ Driver Quick
Reference Guide for information and instructions on the VIP™ Driver.
Single PVP™
(panel)
Backup
DVI-D
connection from
the last PVP™ in
the series
VIP™ Driver
Signal Socket
The VIP™ system's maximum signal load is 24 or less panels on a single signal
cable connection. When using more than 24 panels in a video wall design, you will
need a VIP™ Signal Distributor and additional signal cables to accommodate the
number of panels over 24. A VIP™ Signal Distributor output supports up to 8
signal output lines, providing up to 192 total panels that can be connected from
the VIP™ Signal Distributor. You also can add more VIP™ Signal Distributors to a
VIP™ video wall system. Refer to the VIP™ Signal Distributor Quick Reference
Guide for more information.
Pixel limitation may limit to less than 192 panels.
PVP™ Series User Manual, Rev. 4 15