Signal Connection; Signal Connection Diagram - Chauvet Professional C6 Manuel D'utilisation

Setup And Installation

Signal Connection

The C6 panels receive video signal from the VIP™ Driver via a Neutrik® etherCON® cable, which
must be no more than 100 m long. The Neutrik® etherCON® cable goes from the U MAIN OUT
Neutrik® etherCON® port of the VIP™ Driver into one of the video panels. Neutrik® etherCON®
power-linking cords link the other panels together.
The signal cables must be run from panel to panel in the order in which they will be mapped in the
LED software. The Neutrik® etherCON® signal ports on the panels can be used as either input or
output ports, so signal can transmit in either direction.
After all the panels are connected, the last linked panel will have an empty signal port that can be
used to create a back-up signal infrastructure. To do this, run a Neutrik® etherCON® cable from the
empty Neutrik® etherCON® port of the last panel to the D BACK UP Neutrik® etherCON® port of
the VIP™ Driver.

Signal Connection Diagram

From VIP™ Driver
U MAIN OUT Port
To VIP™ Driver D BACK UP Port
·
Signal transmission can be in either direction, so the first or the last panel in the
signal link can be connected to the VIP™ Driver.
Page 14 of 80 C6 User Manual Rev. 2