Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Connecting (Cabling) Each F4
Connecting Power
The following sections provide information and diagrams on connecting signal and power
between panels.
and Signal Cables
Refer to the
Introduction
or
Operation
sections in this User Manual for available cables
and item numbers.
Signal cable panel connections can use several different configurations. The basic
Connecting
configuration to connect the signal from one panel to the next is as follows.
the Signal Between
1. The source signal is connected to the first panel.
Joined Panels
2. A signal cable is then connected from the first panel.
3. The connections continue to daisy-chain until all panels are connected.
4. The route of the cables used to make the signal connections can vary.
The following diagram is a recommended suggestion for simple signal connections
between panels.
Signal Jumper Cable
DVI or
HDMI
VIP Drive
43Nova
Video Signal Cable in from
VIP Drive 43Nova max.
cable length 100 m/328 ft
May be used to run
a backup line to the
VIP Drive 43Nova
F4 User Manual, Rev. 2
17
Publicité
Table des Matières
