Hansgrohe PHARO Duschtempel 115 EL 40 29040 Mode D'emploi page 38

M o u n t i n g w a l l l p r o f i l e , w a l l - v e r s i o n
ca. 170 520
A
38
Mounting wall profile
Wall-version
15
Position dowels to mount the roof
You need 2 drill holes of 10 mm diameter.
ca. 170
The holes have to be 520 mm from the centre and
1930 mm high, measured from the rim of the shower
tray. Insert supplied dowels.
Seal wall profile
Spread silicone sealant onto the fixing bar.
For display purposes use the removable insta-
lation sealant instead of the supplied Silicone
sealant.
Mounting wall profile
Remove the M12 hexagon nuts, washers, seal rings from
the threaded bolt of the wall profile. Stand wall profile
on the shower tray and secure with seal rings, washers
and the M12 nuts. Lay the earth cable between the
shower tray and washer and nut.
Fit the connecting bar A between the wall profiles. Use
the supplied 3,8x16 countersunk screws.
To fit wall compensating ledge,
position both wall compensating
ledges upright at the corner of
the shower tray, butting on the
up-turned rim. Mark drilling
holes, drill and align vertically
before tightening the screws.