Oster 76110 Manuel D'instruction page 2

16. Do not discard exhausted battery
packs into fire.
17. This appliance is for cutting
purpose use only.
18. Avoid tangling or kinking the cord
while clipping. Should the cord
become tangled or kinked, stop
clipping and straighten the cord.
SAVE THESE INSTRUCTIONS
DO NOT USE THIS CLIPPER UNTIL YOU HAVE READ THESE OPERATING INSTRUCTIONS
OPERATE ON VOLTAGE SPECIFIED ON CLIPPER
ABOUT THIS CLIPPER
CHARGING THE UNIT
Place clipper on charging stand or connect directly to the power supply cord.
This clipper has one control LED INDICATOR
Model Charging 15 minutes left
76110 Green blinking Red solid
78670 Blue blinking Red solid
When clipper battery is low, the LED will turn solid red until battery drains. At
this point, it is recommended to place the clipper on the charger or plug into the
power cord.
19. This appliance is not intended for
use by persons (including children)
with reduced physical, sensory
or mental capabilities, or lack of
experience and knowledge, unless
they have been given supervision
or instruction concerning use of the
appliance by a person responsible
for their safety. Children should be
supervised to ensure that they do
not play with the appliance.
20. Model 078670 is used for trimming
only.
Fully Charged System Error
Green solid Red blinking
Blue solid Red blinking
CHARGING WITH THE CHARGING STAND
• Plug the power cord of the charging stand into an outlet with the rate voltage
for your unit.
• Plug the other end into the charging stand. Note that the cord will only fit into
the charging stand with the proper orientation.
• Ensure that the switch on the unit is in the Off (O) position.
• Insert the clipper into the charging stand so that the top of unit is facing you
and the contacts on the clipper are aligned with the contacts on the charging
stand. The top of the unit is the side with the switch and push button control.
• The LED will begin to turn on if the clipper is inserted properly into the
charging stand and it's making contact.
• If the LED light will not turn on, then re-insert the clipper into the charging stand
and push down gently on the clipper to engage the contacts. If the LED does not
turn on then there may be dirt or grease on the contacts of the charging stand
or clipper. Clean the contacts with an approved cleaning solution and re-insert
the clipper into the charging stand. If the LED still fails to turn on then follow the
return procedure under the warranty and service section.
• The LEDs will stay on as long as the unit is in the charging stand.
CHARGING DIRECTLY WITH THE POWER CORD
• Plug the power cord into an outlet with the rated voltage for your unit.
• Plug the other end into the clipper. Note that the cord will only fit into the
clipper with the proper orientation.
• Ensure that the switch on the unit is in the Off (O) position.
• The LED will begin to turn on if the cord is inserted properly into the clipper.
• If the LED will not turn on, then re-insert the cord into the clipper and push
in gently on the clipper to engage the contacts. If the LED does not on then
there may be dirt or grease on the contacts of the clipper or cord. Clean the
contacts with an approved cleaning solution. If the LED still fails to turn on
then follow the return procedure under the warranty and service section.
3 4