Greenway GWD5570WBC Guide D'utilisation Et D'entretien page 7

or a mild soap and water mixture. For tough deposits, add vinegar and let it soak until the deposits come loose. Then
wash, rinse and dry thoroughly.
Cleaning the Condenser
Vacuum or sweep away the dust from the condenser coils at the back of the
dispenser. For best results, you can purchase a brush designed specifically for
this purpose from your local appliance store. This will improve cooling
and efficiency.
Draining the Reservoirs
Drain the reservoirs before and after cleaning, when going on long vacations or if
not using the dispenser for long periods of time.
IMPORTANT! Unplug the dispenser before performing this procedure.
Dispense hot water until temperature drops to a safe level to avoid the risk of
scalding.
1. Remove the water bottle.
2. Press both dispensing taps until water no longer comes out.
3. Place a bucket beneath the drain valve on the back of the dispenser.
4. Remove the cap and plug from the drain valve and let the water flow into the bucket. Replace the cap and plug.
(A screwdriver or coin can be used to help loosen the drain cap.)
IMPORTANT: Collect the water in a container, not the drip tray.
5. Replace the water bottle (see Installing the Water Bottle).
Cleaning the Inside of the Dispenser
To prevent mineral deposits that can affect the taste and flow of the water and to ensure proper product performance,
your water dispenser must cleaned every 4 months.
1. Unplug the power cord.
2. Remove the water bottle and bottle support collar.
3. Drain the reservoirs (see Draining the Reservoirs).
4. Pour a Greenway water dispenser cleaner or a mixture 4 cups / 1L of
®
vinegar with 4 cups / 1 L of hot water into the reservoir and wait 20
minutes. If using a water dispenser cleaning solution, please follow the
manufacturer's instructions.
IMPORTANT: To avoid water overflow while cleaning the dispenser, always
remove the bottle support collar before pouring water or cleaning solution into
the reservoir (see Figure A).
5. Press both dispensing taps until water no longer comes out.
6. Drain the reservoirs.
IMPORTANT: Collect the water into a container, not the drip tray.
7. Rinse with clean water.
8. Replace the bottle support collar and the water bottle (see Installing the Water Bottle).
IMPORTANT: Drain approximately 4 glasses of water from each tap before initial use. This does not need to be done
with replacement bottles.
www.greenwayhp.com
6
Condenser
coils
Drain
Valve
Cleaning Kit
Available online at
5