Greenway GWD5570WBC Guide D'utilisation Et D'entretien page 3

GROUNDING INSTRUCTIONS
• Improper use of the grounding plug can result in a risk of electric shock causing serious injury, even death.
• This appliance must be grounded. In the event of an electrical short circuit, grounding reduces the risk of electric
shock by providing an escape wire for the electric current.
• This appliance is equipped with a power cord having a grounding wire with a grounding plug and must be
connected into a properly grounded polarized outlet. Consult a qualified electrician if the grounding instructions are
not completely understood, or if doubt exists as to whether the appliance is properly grounded. If the wall outlet is a
standard 2 prong outlet, it is your personal responsibility and obligation to have it replaced with a properly grounded
3-prong wall outlet.
• Do not under any circumstances cut or remove the third (ground) prong from the power cord plug.
• Do not use an adapter plug with this appliance.
• Do not use an extension cord with this appliance. If the power cord is too short, have a qualified electrician install
an electrical outlet near the appliance.
®
YOUR GREENWAY WATER DISPENSER
1. Bottle support collar
2. Ready-To-Dispense indicator lights:
Yellow: "flashing"
"off"
Blue: "on"
"off"
3. "Insta-HOT" (on / off) activation button. (Press once, button starts flashing to signify hot water heating system is
operational. When temperature is reached, flashing light will change to a steady state "on" conditions to signify
water is now ready to be dispensed). You can cancel hot tank operation at any time, simply press the "Insta-Hot"
button a second time and the light will switch off.
4. Hot water dispensing tap (also dispenses room temperature
water when the Insta-HOT feature is not activated)
5. Cold water dispensing tap
6. Removable drip tray
7. Adjustable COLD water thermostat (rear of dispenser)
8. Drain valve (rear of dispenser)
9. Condenser coils (rear of dispenser)
Low water level inside internal reservoir. Hot water heating system cannot be activated.
(you must replenish water supply)
Internal reservoir water level is sufficient to activate hot water heating system
The cold water has reached optimum temperature and is ready for dispensing
The cooling cycle is in progress, it is possible to dispense water during the cooling cycle,
however, optimum cooling temperature may not yet be achieved.
1
2
4
5
2
3
7
6
8
9
1