Operating Instructions; Introduction; Technical Data - BRAVILOR BONAMAT HM 505 Mode D'emploi

1. Operating instructions

To operate the milk heater properly and safely, read the following instructions carefully.
1.1

Introduction

The model HM 505, HM 510 and HM 520 milk heaters work with the "bain-marie" (double
saucepan) system, in which the milk reservoir is suspended in a pan 0acket) of hot water. a
thermostat keeps the water in the jacket at the selected temperature.
The thermostat can be set to the desired temperature with an outside knob, which can also be
used to switch off the entire appliance.
For the appliance to function properly, the water in the jacket must be kept at the correct level,
which can be checked by means of the level gauge.
In the unlikely event that the water in the jacket should be insufficient, overheating is
prevented by a safety device which can be reset on the outside of the appliance. A dipstick with
a small cup which rests on the surface of the milk shows the quantity of milk in the appliance
1
8
9
10
11
The following accessories come with the appliance:
• cover with dipstick
• washing-up brush
• level gauge brush
1.2

Technical data

capacity
milk temperature
voltage 1 (50/60Hz)
power 1
voltage 2 (50/60Hz)
power 2
water capacity (jacket)
2
3
4
1. inlet for water
2. cover with dipstick
3. outside of water jacket
4. handles
5. cord inlet with connecting cord
6. reset knob for boiling-dry protection
5
7. on/off and adjustment knob
6
8. level gauge
7 9. cap
10. tap
11. pilot light
HM 505
5 litre
30° - 85 °C
220 - 240 V~
2000 - 2380 W
-
-
± 3 litre
HM 510
10 litre
30° - 85 °C
220 - 240 V~
2000 - 2380 W
220 V~
3000 W
± 5.5 litre
HM 520
20 litre
30° - 85 °C
220 - 240 V~
2000 - 2380 W
220 V~
3000 W
± 9.5 litre
EN
1