eurodib S2F2 Manuel D'utilisation page 6

· As the hotplate is only heated up indirectly via the bottom of the cookware, over spilling
food cannot stick and burn and there is hardly any danger of burns for the user. The
glass ceramic is only heated up by the hot cookware.
· Once you take the cookware off the hotplate, the device automatically switches to
standby mode.
· The device detects whether suitable cookware is placed on the hotplate. If this is not
the case, no energy is transmitted.
Operating of the device
· Insert the plug into a suitable outlet.
· To turn the power on, press the ON/OFF button once. The power light will turn a steady
red and heating will begin.
· Press the Function Key POWER once. The preset power stage "5" is selected and the
device turns on.
· With the + / - Keys, you can change the settings at any time in a range from 1 – 10.
· Press the Function Key TEMP. Once select the temperature. The preset temperature
stage "270℉" is selected and the device turns on.
Two sides at the HEAT function, when one side is at level "5", the other side will start to
adjust the heating level. The max level of two sides is 10.
One side at the HEAT function, the other side is at the TEMP function, the max of the
HEAT function is "5".
· With the + / - keys, you can change the settings at any time in a range from 150-450℉.
(Temperature stages: 150， 180， 210， 240， 270， 300， 330， 360， 390， 420 and 450℉)
· Timer Function.  A fter the selection of the temperature mode press the button TIMER
key once. The display shows the number "0". With the + / - keys, you can now select
the operating time in 5-minute intervals (up to max. 150 minutes), and reducing 1
minute. Then the display counts down the duration in minutes. Once the time is up, an
acoustic signal sounds and the device automatically goes into standby mode. Press
the ON/OFF button to restart the unit.
· After cooking is completed, press the ON/OFF button again to turn off the unit.
· After the cooking time reach 150 mins, the LED will show "EE" and sound, and then the
unit will enter the standby mode. Press the ON/OFF button to restart the unit.
Remarks:
1. This double induction cooker is power-invariance. Total power levels of left &
right plates are in 10 grades. Max. power of individual plate is grade-10.
2. When operating two plates at the same time, as total power is in 10 grades,
increasing power of either one plate, power output of another side shall be reduced
automatically. So it will keep max power as 10 grades.
Notice:
· If using the unit in TEMP or HEAT Function, not setting the TIMER Function, but when
the unit is used 150 mins, the LED display shows EE code and sound. The unit will
4