Publicité
or1
G UA R A N T E E
2
or1
UK
IMPORTANT
Please read this manual carefully BEFORE using your
helmet for the first time.
Following the instructions will keep your helmet
effective and SAFE.
Remember to keep the manual in a safe place.
It contains instructions, which are EXTREMELY
IMPORTANT for your safety.
PLEASE REMEMBER!!! We have done our best to be as
clear and explicit as possible. However, should you
find the instructions unclear, or have any questions
or require further information, please do not hesitate
to contact us by post or e-mail.
INFORMATION FOR USERS
- To insure an adequate protection, this helmet must
fit closely and be securely attached
- Any helmet that has sustained a violent impact
should be replaced
- Warning! Do not apply paint, stickers, petrol or
other solvents to this helmet. Use only warm soapy
water to clean the helmet surface
ECE R22.05
- 2 -
Congratulations for buying our LZR-OR-1 helmet!
You can be sure that you have done an excellent
choice.
Enjoy it and have a happy ride, LZR protects Your
Freedom...
ADVICES
FASTENING
Your helmet will be useless if it's too big or not
properly fastened. Always buy a helmet to your
exact size and always fasten it properly.
MODIFICATIONS
Never modify your helmet in any way. Modifications
could result in lowering the effectiveness of your
helmet.
DAMAGED HELMET
When your helmet sustains a severe shock, part of
its structure and lining may have been deteriorated
by absorbing the energy of the impact. These
damages may not be visible to the eye. In this case,
do not hesitate to replace it.
CARE AND MAINTENANCE
Clean the outside and inside of your helmet
regularly. Use a soft cloth and warm or slightly
soapy water. NEVER USE GAS OIL, SOLVENTS, PETROL
OR OTHER AGGRESSIVE PRODUCTS.
The padding is removable to make it easy to clean.
Again, only use warm or slightly soapy water. Hand
wash and drip dry.
STORAGE
After washing your helmet, store it inside a bag, in a
dry temperate place. Avoid prolonged storage in a
very illuminate place.
DURABILITY
Over time, some wear marks can appear on
safety elements of your helmet, such as: wearing
or fraying of the strap, malfunction of the buckle,
cracking or crumbling of the inner liner, cracking
of the shell, ... In this case, contact your dealer to
check or replace your helmet.
HANDLING
WILL IT STAY ON ? (FIG. 1)
You want to know If the helmet you bought will
stay firmly on your head in a crash. Make sure the
chinstrap is done up and tilt your head forward. Ask
someone to try and roll the helmet off your head by
carefully pushing up from the rear of the helmet at
its base. If you can roll it off in the showroom, then
it's sure to come off in a crash.
INSTRUCTION - DOUBLE D BUCKLE:
TO FASTEN AND OPEN THE CHIN STRAP (FIG. 2)
1. Fasten the chin strap by passing the end of the
strap through the 2 rings as shown on picture A,
then pull it comfortably tight for a secure and
snug fit.
2. To remove the helmet pull the little red tab
outwards, the strap tension will be released as
shown on picture B. Then unthread the chin
strap.
Warning ! – The red snap placed at the end of the
chin strap must NOT be used instead of the Double
D buckle.It has been designed to avoid the chin
strap flapping in the wind at high speed.
HOW TO ADJUST THE VISOR
• Nothing could be simpler. Unscrew the central
upper screw to unlock the central adjusting
device. (FIG. 3C)
- 3 -
Publicité
