Pioneer DDJ-SR Guide De Démarrage Rapide page 11

Playing tracks and outputting the sound
The following describes the procedure for outputting the channel 1
sound as an example.
Set the volume of the devices (power amplifier, powered speakers,
etc.) connected to the [MASTER OUT1] and [BOOTH OUT/MASTER
OUT2] terminals to an appropriate level. Note that loud sound will be
output if the volume is set too high.
Mixer section
4
9
5
a
6
7
8
c
Front panel
d
Rear panel
g
b
f
e
h
4 TRIM control
5 EQ (HI, MID, LOW) controls
6 FILTER control
7 Headphones CUE/TAP button
8 Channel fader
9 MASTER LEVEL control
a HEADPHONES MIX control
b Level indicator switch
c Crossfader
d HEADPHONES LEVEL control
e CROSS FADER REVERSE switch
f CROSS FADER CURVE control
g BOOTH LEVEL control
h BOOTH/MASTER selector switch
1 Set the positions of the controls, etc., as shown
below.
Names of controls, etc.
MASTER LEVEL control
TRIM control
EQ (HI, MID, LOW) controls
FILTER control
Level indicator switch
Channel fader
CROSS FADER REVERSE switch
BOOTH/MASTER selector switch
BOOTH LEVEL control
2 Press the [ ] button to play the track.
3 Move the channel fader away from you.
4 Turn the [TRIM] control.
Adjust [TRIM] so that the orange indicator on the channel level indicator
lights at the peak level.
5 Turn the [MASTER LEVEL] control to adjust the audio
level of the speakers.
Adjust the sound level output from the [MASTER OUT1] and [BOOTH
OUT/MASTER OUT2] terminals to an appropriate level.
When the [BOOTH/MASTER] selector switch is set to the [BOOTH]
position, the [BOOTH LEVEL] control can be used to adjust only the
audio level output from the [BOOTH OUT/MASTER OUT2] terminal to
an appropriate volume.
Position
Turned fully counterclockwise
Turned fully counterclockwise
Center
Center
[CH1/2] position
Moved forward
[OFF] position
[MASTER] position
Turned fully counterclockwise
11
En