Settings; Introduction To Parameter Codes; Scb-10 Expansion Pcb Settings - BDR Thermea Group SCB-10 Notice D'installation Et D'utilisation

en

5 Settings

5 Settings
5.1

Introduction to parameter codes

Fig.30 Code on a HMI T-control
00:12 ...... ........ ....... ......
....................
..... ... ....... .... .. ..... ....
....... .... .. ..... ....
....... ........... CP010
..... ... ....... ....
..... ... ....... ....
..... ... ....... .... .. ..... ....... .... ..... .......
........ .......
Fig.31 First letter
Fig.32 Second letter
Fig.33 Number
5.2

SCB-10 expansion PCB settings

Tab.37 Navigation for userbasic installer level
Level Menu path
User
Basic installer
(1) See the column "Submenu" in the following table for the correct navigation. The parameters are grouped in specific functionalities.
(2) See the column "Submenu" in the following table for the correct navigation. The parameters are grouped in specific functionalities.
Tab.38 Factory settings at userbasic installer level
Code Display text
AP074 Force summer
mode
AP077 Max. display
level
AP081 Device short
name
36
.........
.......
...
......
.....
CP010
AD-3001373-02
CP010
AD-3001375-01
CP010
AD-3001376-01
CP010
AD-3001377-01
> Submenu
(1)
> Installation Setup > SCB-10 > Submenu
Description
The heating is stopped. Hot water
is maintained. Force Summer
Mode
Maximum Level of parameters
and signals to display on MK
Shortname of the device
The controls platform makes use of an advanced system to categorise
parameters, measurements and counters. Knowing the logic behind these
codes, makes it easier to identify them. The code consists of two letters
and three numbers.
The first letter is the category the code relates to.
A Appliance: Appliance
B Buffer: Hot water tank
C Circuit: Zone
E External: External options
N Network: Cascade
The second letter is the type.
P Parameter: Parameters
C Counter: Counters
M Measurement: Signals
The number is always three digits. In certain cases, the last of the three
digits relates to a zone.
Important
The table shows the factory setting for the parameters.
> Parameters, counters, signals > Parameters
(2)
Range
0 = Off
1 = On
1 = End user
2 = Installer
3 = Installer advanced
4 = Lab
5 = Controls
Development
Submenu Submenu
Outdoor
temperatur
e
System
Functionalit
y
System
Functionalit
y
7747028 - v.01 - 25112019
Default
setting
0
3
S10