DWT SDS21-355 DN Notice Originale page 21

Symbol
I
power tool designation
The power tool is designed for the dry cutting of metal
workpieces, sections, pipes, etc� in stationary mode�
The power tool is designed for right-handed users only�
Power tool
components
1 Ventilation slots
2 Body
3 Carrying handle
4 Lock-on button
5 On / off switch
6 Handle
7 Guard cover
8 Spindle lock
9 Movable guard cover
10 Cutting disc *
11 Base plate
12 Chain
13 Cutting depth adjustment bolt
14 Cutting depth adjustment bolt lock-nut
15 Wrench *
16 Adjusting bolt
17 Adjusting stop
18 Rotary stop
19 Lead screw
20 Tiltable lever
21 Clamping handle
22 Wing screw
23 Cover
24 Screw of protective plate
25 Protective plate
26 Pin
27 Locking handle (for carrying)
28 Scale
29 Spindle
30 Inner flange
31 External flange
Meaning
Angle bar workpiece�
Protection class�
Attention� Important�
Useful information�
Do not dispose of the power
tool in a domestic waste
container�
DWT
32 Washer
33 Cutting disc fixing bolt
* Optional extra
Not all of the accessories illustrated or described
are included as standard delivery.
Installation and regulation
of power tool elements
Before carrying out any works on the power tool it
must be disconnected from the mains.
Do not draw up the fastening elements
too tight to avoid damaging the thread.
Mounting / dismounting / setting-up of
some elements is the same for all power
tool models, in this case specific models
are not indicated in the illustration�
Carriage position (see fig. 1-2)
The power tool can be moved only when positioned
for carriage (the body pulled down and fixed). When
moved, the power tool has to be held only by carrying
handle 3, or underneath baseplate 11�
Before starting any work, position the power tool for
operation�
[SDS21-355 DN]
• Slightly press handle 6 (see fig. 1.1).
• Remove chain 12 from pin 26 and lift the body up
smoothly� Lower the housing slightly and put links of
the chain 12 onto the pin 26 (see fig. 1.2-1.3).
• To position the power tool for carriage, do the indi-
cated operations in a reverse order�
[SDS24-355 DN]
• Slightly press handle 6 (see fig. 2.1).
• Move the locking handle 27 as shown in fig. 2.2.
• Lift the body up smoothly (see fig. 2.3).
• To position the power tool for carriage, do the indi-
cated operations in a reverse order�
Adjustment of the cutting depth (see fig. 3)
With the help of the bolt 13 and the lock-nut 14, adjust
the depth of cut so that the cutting disc 10 in the lower
position does not touch construction components of
the power tool (see fig. 3).
• Loosen lock-nut 14�
• Adjust the cutting depth by turning bolt 13 in or out�
• Tighten lock-nut 14�
Installation and removal protective plate (see fig. 4)
Fig� 4 shows protective plate 25 mounting / dismount-
ing operations�
Setting of cutting angle (see fig. 5)
• Loosen adjusting bolts 16 with help of wrench 15
(see fig. 5.1).
English
21