Operation; Before Starting - DK2 POWER OPT118 Guide De Montage

OPERATION

BEFORE STARTING

Clear area of all people and property that could be damaged. THINK SAFETY. Stones
from the soil can be projectiles and can cause injury. Wear safety glasses, hearing
protection, and gloves.
DO NOT wear loose fitting clothes that could get stuck in the machine's moving parts,
only trench soil and sand.
Children SHOULD NOT run this equipment, stay alert of your surroundings and persons
that could appear in the digger path while you are working.
NEVER APPROACH AUGER OR CHAIN WHILE RUNNING - TURN TRENCHER OFF.
BEFORE YOU DIG, HAVE THE AREA VERIFIED FOR ANY UTILITIES IN THE GROUND.
BURIED ELECTRICAL LINES, GAS LINES, ETC.
Pull the unit back, lower the cutting chain to the desired depth, there are multi levels set
by the hand crank lever.
Make sure the forward brake is lowered into the wheel brake gears. Loosen the center
bolt in the brake bar to set the FORWARD brake system before digging. This will hold
your trencher from moving forward while digging. The unit will roll free in reverse pull.
Tighten the bolt to release the dual wheel brakes so your unit will roll freely for
transportation.
PERFORMANCE OPERATION
Your trencher has quick change teeth. The digger points snap out by tapping with
a hammer and replacements snap back into the socket. Use a block of wood when
replacing the teeth. Never strike the cutting tips with a hammer.
ALL PARTS ARE AVAILABLE FROM DK2POWER AT 702-331-5353
19