Di4 SteamClean Caddy XL Mode D'emploi page 22

REMARK:
please make sure that no residual water in the boiler before adding water. Pour out the rest water after
finish using and clean the boiler. There will be calcification inside which may clog the steam after long
time.
Method of cleaning boiler: first add small amount of water in the boiler, fully shaking hands rock the
machine, and than pour out the water completely. Suggest you can repeat above action if the water
contains a lot of impurity.
In order to get idea steam, please be sure to fill maximum 1.5 liter water. You can check the scale in the cup.
Please screw the safety valve when water filled.
Do not inject any liquid except clean water
2. Power on
Please ensure that the boiler with water and the safety valve in a tight status before power on.
Put the plug into socket and open the power switch. If the power is on, the red light will on.
Do not use wet hand to touch the power
Do not use any power cord & socket in broken status.
3. Operation
After about 7 minutes, the green light will show on, it means steam is ready.
Hold the steam gun by hand, press the children lock. At the same time, use other four finger to press the
steam trigger. Steam come out directly.
The green light will be on and off during usage. If it is on, it means the pressure reach to 4bar, but it will
not influence use when off.
There will be some water come out at first time as of condensate in the pipe. Do not use to clean carpet,
ironing clothes etc. Suggest you can spray to some container. It will be dry after 2-3seconds.
Please choose the appropriate accessories to clean according to the actual situation. Detailed please
refer to the accessories instructions.
Do not screw the safety valve during using or power is on or hot steam & water will be
released
Red light show on it means short of water.
Following steps from 1 ~3 for repeat using.
22