Di4 Aspirovac Ultraforze 40V Mode D'emploi page 16

CLEANING OF ROLLING BRUSH
• Shaped screwdriver or corn should be used for rotating rolling brush cover knob according to requi-
rement in the drawing, and then the rolling brush cover can be released;
• The rolling brush cover can be removed according to direction in the drawing, and then the rolling
brush can be removed from the slot for cleaning (water washing is not allowed).
• The product should be assembled according to sequence opposite to disassembly after cleaning or
replacement.
TROUBLESHOOTING
MALFUNCTION POSSIBLE REASONS
MOTOR DOES Battery is power off
NOT TURN ON
The hand-held vacuum cleaner
is not properly installed in the
body assembly (because the
body assembly requires a hand-
held vacuum cleaner to provide
power, which itself cannot work
independently)
SUCTION Dust cup has been full of dust
REDUCED
The Filter is full of dust
Air duct of the Electric brush is blocked
or roller brush stall
The battery is low
CHARGING The hand-held vacuum cleaner is not
INDICATOR DOES fitted to the body assembly
NOT FLASH
RECYCLE WHEN
CHARGING
THE USING The charging time is insufficient
TIME IS NOT
ENOUGH AFTER
CHARGING
16
SOLUTIONS
Charge the vacuum cleaner
Correctly install the hand-held
vacuum cleaner and body assembly
Dump the dust in the dust cup
Clean or replace the Filter
Clean the garbage
attached to the electric roller brush
Fully charge the battery as indicated
in the charging section
Properly assemble the hand-held
vacuum cleaner and the body
assembly
Fully charge the battery as indicated
in the charging section