Di4 Aspirovac Ultraforze 40V Mode D'emploi page 15

Connection of handle and vacuum cleaner
• Please firstly arrange handle spring lines smoothly during connection. Main body component should
be aligned, handle should be inserted into main body, and slight force should be slightly applied in
the assembly process until 'click' locking sound is heard after handle is cooperated with main body.
Handle can be pulled back, thereby ensuring that the handle cannot be pulled off.
INSTRUCTIONS FOR USE
Charging of vacuum cleaner
• When the vacuum electricity cleaner electricity is insufficient, please timely charge the vacuum
cleaner; when the voltage is too low, automatic power-off protection phenomenon can appear for
the vacuum cleaner in order to protect the battery. The vacuum cleaner must be charged. Please
ensure that the vacuum cleaner is provided with battery pack capable for normal charging and dis-
charging before charging. The battery pack should be reliably installed with the adapter component.
The adapter plug should be inserted on AC power supply socket. The charging indicator is 'red' under
the condition. It is obvious that the vacuum cleaner is charged at present. (Charging voltage is 100 ~
240V, please do not charge charger capable of using the charging port of the vacuum cleaner.)
• When the charging indicator is changed from 'red' to 'green', it is obvious that the battery of vacuum
cleaner has been fully charged, the plug should be timely removed from the AC socket.
Note: 1. When the vacuum cleaner is used for the first three times, please ensure that the charging
time is up to 4 hours each time.
• When the charging indicator flashes between red and green repeatedly and the flash frequency is
twice/second, please timely send it to maintenance department for repair.
Floor brush dust sucking
The floor brush should not be set in vertical state, and dust can be sucked by pressing the switch
button.
Note: (1) Electric floor brush can be used on the hard floor, floor tile, and undercoat carpet for sucking
dust.
MAINTENANCE AND CLEANING
• Switch off the appliance and let it cool before undertaking any cleaning task.
• Clean the outside of the appliance with a damp cloth. Do not use abrasive products or solvents.
• Do not submerge the appliance in water or any other liquid. Make sure that no water enters the
appliance.
• Remove any dirt (hair and other fibers) tangled around the brush and wheels.
CLEANING DUST CONTAINER AND FILTER
• Uncouple the handheld vacuum cleaner. Dismantle it by pressing the release button for dust con-
tainer.
• Take out the filter and filter protector. Empty the dust container and filter.
• If the parts are heavily soiled, wash the dust container, filter and its protector under running water
with detergent. Check that all the parts are completely dry before fitting them back.
15