Di4 Aspirojet Duo Mode D'emploi page 14

This device can only be used with the adapter model supplied
with the device and powered at very safety voltage indicated
on the appliance specifications plate.
Follow the DEVICE CHARGE instructions in order to charge it.
Follow the BATTERY REMOVAL instructions for removal of
the batteries from the device.
The cord of the adaptor cannot be replaced; if the cord is da-
maged ,the adaptor shall be scrapped.
Plug of adaptor must be removed from socket-outlet before
cleaning or maintaining the appliance.
IMPORTANT WARNINGS
Prior to plugging in the product, check that your mains voltage is the same as the one indicated on
the product label.
The mains connection cable must not be tangled or wrapped around the product during use.
Do not pull on the connection cord in order to unplug it.
Do not use, connect or disconnect the device to the mains with your hands or feet wet.
Proceed according to the conservation and cleaning section of this manual for cleaning.
Unplug the product immediately from the mains in the event of any breakdown or damage and con-
tact an authorised Technical support service.
In order to prevent any risk of danger, do not open the device. Only qualified technical personnel from
the brand´s Official Technical support service may carry out repairs or procedures on the device.
Any incorrect use or improper handling of the product shall render the warranty null and void. Only an
authorised technical support service centre may carry out repairs on this product.
This appliance is designed exclusively for domestic use, in no case should be a commercial or indus-
trial use. In case of misuse or tampering with the product, it will be out of warranty.
Do not use the appliance to sharp objects (pins, pins, nails, glass, etc), incandescent objects (mat-
ches, cigarettes)
B&B TRENDS SL. disclaims all liability for damages that may occur to people, animals or objects, for
the non-observance of these warnings.
INSTRUCTIONS FOR USE
HOW TO ASSEMBLE THE UNIT
1. Assemble the filter
Put the filter into the filter support,
Then turn the filter as right clock direction
To the stop position.
Turn left direction to take out the filter.
14