Chauvet Professional WELL PANEL WIRELESS EVENT LED LUMINAIRE Guide De Référence Rapide page 3

AC Power
This product has an auto-ranging power supply that can work with an input voltage range of 100–240 VAC, 50/60 Hz.
AC Plug
Connection
AC Live
AC Neutral
AC Ground
To eliminate wear and improve its lifespan, during periods of non-use completely disconnect the
product from power via breaker or by unplugging it.
Battery Charge Notes
This product is equipped with a built-in rechargeable lithium ion battery.
• Avoid depleting the battery below 10%.
• For best results, charge the battery in a temperature between 32 ºF (0 ºC), and 95 ºF (35 ºC).
• When charging the battery, keep the product at least 1 m from any open flame or hot plate.
• If the battery is completely discharged, the device cannot be turned on immediately when the charger is
connected. Allow a depleted battery to charge for a few minutes before turning on the device.
• While charging, the device may heat up. This is normal and should not affect the device's lifespan or performance.
If the battery gets hotter than usual, the charger may stop charging.
• Always charge the battery with the product in an upright position.
• Do not charge the battery for more than 24 hours.
Storage Notes
• Store charged product(s) in a dry environment, away from direct sunlight.
• Charge or discharge the battery to approximately 50% of capacity before storage.
• Lithium-Ion batteries continue to slowly discharge (self-discharge) when not in use or while in storage. Routinely
check the battery's charge status.
• Store the battery at temperatures between 41 °F and 68 °F (5 °C and 20 °C).
• Always store the product in an upright position (≤ 10° tilt)
DMX Linking
The WELL Panel will work with a DMX controller using a 5-pin DMX data connection or a wireless DMX connection. A
DMX Primer is available from www.chauvetprofessional.com.
DMX Connection
The WELL Panel uses a wireless or 5-pin DMX data connection for its DMX personalities: 4Ch, 8Ch, 12Ch, 13Ch, and
21Ch. See the User Manual for information about connecting and configuring the product for DMX operation.
Master/Slave Connection
The WELL Panel uses the DMX data connection for its Master/Slave mode. See the User Manual for information about
connect and configure the product for master/slave operation.
WELL Panel QRG Rev. 6
QUICK REFERENCE GUIDE
Wire (U.S.)
Black
White
Green/Yellow
Wire (Europe)
Brown
Blue
Green/Yellow
.
EN
Screw Color
Yellow/Brass
Silver
Green
2