Calculated Industries SCALE MASTER CLASSIC 6020 Guide De L'utilisateur page 9

Rolling or Entering a Custom Scale
1) Press [Mode] until "1: CUS 1"
appears in the scale box display.
2) Press [Subtract/Count] and [Scale]
simultaneously. "
the main display. If you are
entering a scale, skip to step 4.
3) Roll desired dimension. "
now appears in the main display.
Note: For greater accuracy, you may want to roll
the known distance several times, then
enter the distance times the number of rolls
(for example, roll a distance 5 times and if
the distance is 3 feet, enter 15 feet).
4) Press [Scale]. The display will show
zeroes and the units of measurement
annunciator will begin flashing (
for Imperial Mode,
Mode).
5) If you do not want to change the
units of measure, skip to step 6. If
you want to change the units of
measure, press [M1+] until you
reach the desired units.
6) Press [Scale] to begin setting the
scale distance. The left-most digit
will begin flashing. Press:
[M1+] to increment this digit,
[Subtract/Count] to decrement,
[Scale] to advance to next digit,
[Mode] to move back one digit.
7) Continue to press [Scale] until all
digits are set and the display returns
to zero. The scale is now stored.
" will appear in
ROLL
MM
ROLLING
FT
for Metric
9 – User's Guide
"
-
IN