Adjusting The Wheel; Using The Scale Master Classic; Rolling" A Measurement - Calculated Industries SCALE MASTER CLASSIC 6020 Guide De L'utilisateur

Adjusting the Wheel

To adjust the Celcon
take a small, flat-head jeweler's screw-
driver and slightly rotate the screw
near the wheel tip. Rotating the screw
between 1 ⁄4 to 1 ⁄ 3 turn should adjust
the wheel between free spinning
(which is too loose) to skidding (which
is too tight).
U
SING THE

"Rolling" a Measurement

To take a measurement with the Scale
Master Classic:
1) Switch the unit on. Press [Reset] to
clear the display.
2) Select your scale mode by press-
ing the [Mode] key. Then press the
[Scale] key to select your scale.
3) Begin rolling. The display will reg-
ister your measurements.
To ensure accurate measurements,
be sure to hold the unit upright
and start and stop the SMC at the
exact points you are measuring.
4) Press the appropriate key if you
want to store this measurement
(ex. [M1+] to store as length, [M2x]
to store as width).
5) Press [Reset] to clear the display
and begin a new measurement.
S M
CALE
polymer wheel,
®
®
ASTER
5 – User's Guide
C
LASSIC