Publicité
Les langues disponibles
Les langues disponibles
Serving
•
Before serving, ensure to locate the drip tray(s)
in place.
•
Pull the tap toward you to begin pouring.
•
Raise the tap handle to close the tap.
Cleaning, Care &
Maintenance
Switch off and disconnect
from the power supply before
cleaning and maintenance.
•
Warm, soapy water is recommended for
cleaning. Cleaning agents may leave harmful
residues. Wipe the exterior with a damp cloth.
•
Empty and clean the drip trays regularly.
•
A POLAR agent or qualified technician should
carry out repairs if required.
Cleaning the cabinet
The interior and exterior can be cleaned using
soap and warm water. If this is not sufficient,
try ammonia and water or a non-abrasive liquid
cleaner. When cleaning the exterior, always rub
with the "grain" of the stainless steel to avoid
marring the finish.
Do not use an abrasive cleaner because it will
scratch the stainless steel and plastic and can
damage the breaker strips and gaskets.
Cleaning the Condenser Coil
The condenser coil requires regular cleaning, with
the recommended frequency of every 90 days.
In some instances, you may find there is a large
amount of debris and dust or grease accumulated
prior to the 90-day period. Thus the condenser coil
should be cleaned more frequently.
GE632-GE633_ML_A5_v1_20210423.indb 9
GE632-GE633_ML_A5_v1_20210423.indb 9
If the buildup on the coil consists of only light dust
and debris the condenser coil can be cleaned with
a simple brush. Heavier dust buildup may require
a vacuum or even compressed air to blow through
the condenser coil.
If heavy grease is present, there are de-greasing
agents available for refrigeration use and
specifically for the condenser coils. The condenser
coil may require a spray with the de-greasing agent
and then blown through with compressed air.
Failure to maintain a clean condenser coil can
initially cause high temperatures and excessive run
times, continuous operation with dirty or clogged
condenser coils can result in compressor failures.
Neglecting the condenser coil cleaning procedures
will void any warranties associated with the
compressor or cost to replace the compressor.
In order to maintain proper refrigeration
performance, the condenser fins must be
cleaned of dust, dirt and grease regularly. It is
recommended that this be done at least every 3
months. If conditions are such that the condenser
is totally blocked, the frequency of cleaning
should be increased. Clean the condenser with a
vacuum cleaner or stiff brush. If extremely dirty, a
commercially available condenser cleaner may be
required.
Stainless Steel Care
To maintain the stainless steel exterior of your Polar
item, please consider the following information:
Never:
•
Use abrasive Scourers or scrubbing pads, etc.
•
Use Chlorinated or acidic detergents
•
Allow anything e.g. food, dirt, cleaning
chemicals to remain on the surface for longer
than necessary, clean them off right away.
•
Allow the surface to remain wet.
Do:
•
Clean often.
•
Use soft Cloths or plastic Scourers.
•
Rub with the grain of the metal, rather than
across it.
•
Use detergents and polish designed for
cleaning Stainless Steel.
•
Ensure that the cleaning products are washed
off fully and that the steel is left dry.
UK
9
2021/4/23 13:26
2021/4/23 13:26
Publicité
