BEGLEC JB SYSTEMS SPACE-1 Mode D'emploi page 8

ENGLISH
5. Controlled by iLEAD-controller:
If you use iLead 0824 controller, Please refer to the following diagram to address your
DMX512 channel for the first 4 units.
DMX address can be set remotely by the IL-0824 controller. No need to calculate the
DMX channels of each fixture in the chain.
(Following DMX address setting is based on that all the lighting fixtures are linked
together controlled by the 8-channel iLead IL-0824 controller).
MAINTENANCE
• Make sure the area below the installation place is free from unwanted persons during
servicing.
• Switch off the unit, unplug the mains cable and wait until the unit has been cooled down.
During inspection the following points should be checked:
• All screws used for installing the device and any of its parts should be tightly fastened
and may not be corroded.
• Housings, fixations and installations spots (ceiling, truss, suspensions) should be totally
free from any deformation.
• When an optical lens is visibly damaged due to cracks or deep scratches, it must be
replaced.
• The mains cables must be in impeccable condition and should be replaced immediately
when even a small problem is detected.
• In order to protect the device from overheat the cooling fans (if any) and ventilation
openings should be cleaned monthly.
• The interior of the device should be cleaned annually using a vacuum cleaner or air-jet.
• The cleaning of internal and external optical lenses and/or mirrors must be carried out
periodically to optimize light output. Cleaning frequency depends on the environment in
which the fixture operates: damp, smoky or particularly dirty surroundings can cause
greater accumulation of dirt on the unit's optics.
• Clean with a soft cloth using normal glass cleaning products.
• Always dry the parts carefully.
• Clean the external optics at least once every 30 days.
• Clean the internal optics at least every 90 days.
Attention: We strongly recommend internal cleaning to be carried out by qualified
personnel!
JB SYSTEMS® 11/60
OPERATION MANUAL
SPACE-1 Laser
ENGLISH
SPECIFICATIONS
Mains Input: AC 230V, 50Hz
Fuse: 250V 2A fast blow (20mm glass)
Sound Control: Internal microphone
DMX connections: 3pin XLR male / female
Laser Power: 30mW Green CW laser (λ = 532nm)
Scanner speed: 43,776mS "Continuous Scanning Technology"
Laser Class: 3R
Laser Safety Standard: EN60825-1:1994 + A1:2002 + A2:2002
Size: 32 x 20,5 x 10cm
Weight: 2,3kg
Every information is subject to change without prior notice
JB SYSTEMS® 12/60
OPERATION MANUAL
SPACE-1 Laser