Editing Scenes - Ghost Mydmx Manuel

Scanner buttons 1-12
Program
EXAMPLE: Program 8 scenes with channel 1-8 at full in sequence into bank 2 and assign
these scenes to scanner 2.
1. Program enable.
2. Tap the Scanner 2 button to turn on its fader control.
3. Tap the Page Select button to select Page A.
4. Push Fader 1 to the top position.
5. Tap the MIDI/Rec button.
6. Select bank 2 using Bank Up/Down button.
7. Tap the Scene 1 button to store the first scene.
8. Repeat steps 4-7 until all 8 scenes have been programmed into bank 2.
9. Tap the Scanner 2 button again to turn off its fader control.
10. Press the Program button for 3 seconds to exit Programming mode.
2.2.1

Editing Scenes

BANK
Page 34
8. Repeat steps 3-7 until all desired scenes have been
programmed into memory. Tap the Scanner button again to
turn off its fader control.
To assign another scanner (fixture), you may tap the
corresponding Scanner button to turn on its fader control,
then you may begin your programming again.
9. If you wish not continue your programming, press and hold
down the Program button for three seconds to exit Pro
gram mode, the blinking light in the Segment Display goes
out indicating this selection.
1. Program enable.
2. Tap the Bank Up/Down button to select the bank that
contains the scene you wish to edit.